Surface Mount Kit Leaflet A5

PDF Viewing Options

Not Your Device? Search For Manuals or Datasheets below:


File Info : application/pdf, 2 Pages, 452.41KB

Document DEVICE REPORTevolt-2982 eng au
INSTALLATION GUIDE

EV-RAZOR-LEDFIRE-SM-KIT
The Razor Surface mount kit (2981 EV-RAZOR-LEDFIRE-SM-KIT & 2982 EV-RAZOR-LEDFIRE-SM-KIT-B) is a
modular attachment to the Razor that allows the Razor-Ledfire or Razor III emergency exit signs to be surface
mounted or suspended by either a rod mount or jack chain.*

1
SURFACE MOUNT
Prior to assembly, the Surface Mount base must be fastened to the ceiling.
Punch out to suit 20 conduit

365mm Surface mount above

60mm

A ASSEMBLY
Carefully disassemble cover with flat blade screwdriver.

Select appropriate fastener (e.g. concrete masonry anchor or timber).
Cable tie locations (strain relief) Mains entry 1
OR
Mains entry 2
Swap existing battery clips with supplied clips prior to installing
Fold in

Cut power plug off and prepare the bared wires
for connection to the terminal block

Wiring harness: refer to schematic diagram

Document Part Number: 602255_V1.4 2918 EV-Razor-Ledfire-SM-Kit 23.April 2015 *Rod mount and jack chain supplied separately.

B
WIRING SCHEMATIC

L

N L' DA2 DA1

L

N L' DA2 DA1

2
ROD MOUNT INSTALLATION
The rod mount is suitable with tubes ranging from 0-2 metres in length. Refer to rod mount instructions for connection.

RAZOR LEDFIRE
3
Cable

25 tube (<2m long)

TORQUE TO 1.5 NM MAX.

Rod mount

RAZOR III
SUSPENDED MOUNT
Jack chain When using a jack chain, suitable length ranges from 0-10 metres. ** **Rated jack
chain capacity.
FITTING JACK CHAIN

Spring washer

Do not over tighten.

WARRANTY STATEMENT
Ektor products are distributed in Australia and New Zealand by Evolt Pty Ltd (Evolt). The Australian Consumer Law as well as other Australian laws guarantee certain conditions, warranties and undertakings, and give you other legal rights, in relation to the quality and fitness for purpose of Ektor products sold in Australia. In Australia, our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. What constitutes a major failure is set out in the Australian Consumer Law.Nothing in this Warranty purports to modify or exclude the conditions, warranties and undertakings, and other legal rights, under the Australian Competition and Consumer Act and other Australian laws. Ektor products are warranted in Australia for a period of 12 months from the date of delivery of the product, provided that the products are properly stored, installed, used and maintained in accordance with the instructions contained within their manual. Products that have been altered in any way or used other than in accordance with their instructions are not covered by this warranty. This warranty is not transferrable and is valid only in the hands of the purchaser of the product. The warranty does not cover Ektor products other than those purchased from Evolt. Proof of purchase must be provided to Evolt with any warranty claim. Evolt recommends that the purchaser attaches their proof of purchase to their product manual. Evolt's total liability under this warranty is limited to the cost of repair or replacement of the faulty product. Evolt may satisfy its obligations under this warranty in full by repair or replacement of a faulty product. This warranty does not apply to consumable items such as lamps or batteries or other items that can be classified as consumable. For the avoidance of any doubt, any and all warranties or conditions which are not guaranteed under the Australian Competition and Consumer Act or the Australian Competition and Consumer Regulations 2010 and which are not expressly included in this Warranty as additional warranties or conditions are excluded.This Warranty does not cover loss or damage caused by wear and tear, misuse, incorrect installation or operation, failure to clean and maintain, incorrect voltage or non-authorised electrical connections, adverse external conditions (such as power surges and dips, acts of God, exposure to heat, corrosion, insect or vermin infestation), use of non-authorised or defective parts or globes, or to items that have been repaired other than by Evolt or a repairer approved by Evolt.
TECHNICAL SUPPORT AND TROUBLESHOOTING
For further assistance in using this product, consult your nearest wholesaler or Evolt Pty Limited.
Ph: + 612 9502 1161 Fax: + 612 9502 1154 Email: [email protected] evolt.com.au


Adobe PDF library 10.01 Adobe Illustrator CS6 (Windows)

Search Any Device: