hpml1198-dli-downlights-instruction-sheet-v2
leo.ramon
LED Downlights
Datasheet (pdf / 0.11MB)
D/Light Rnd Fixed Int Drv 90mm C/O LED 7W 3/4/5K Wht - MM Electrical Merchandising
Not Your Device? Search For Manuals or Datasheets below:
File Info : application/pdf, 2 Pages, 109.90KB
Document DEVICE REPORTHPM DLIXXXTRIWELED Downlights Instruction Manual Cat. DLI90TRIWE, DLI110TRIWE DLI90TRIWE 1 Specifications Cat No Supply Voltage Input Power Power Output Lumens Output Colour Temperature (Nominal) Colour Rendering Index (CRI) IP Rating Ceiling Depth Length of Power Cord Lifespan (in open air at 25°C) Beam Angle Ceiling Cutout Size Fascia Diameter DLI110TRIWE Class II construction Dimmable IC-4 Insulation Rating DLI90TRIWE DLI110TRIWE 230-240V a.c 50Hz 7W 6W 690lm (Warm), 740lm (Cool), 680lm (Natural) 3000K (Warm), 4000K (Cool), 5000K (Natural) 80+ IP44 72mm 1m 35,000h 90o 95o Ø90mm Ø110mm 110mm 138mm 2 Installation 1. Cut out a hole in the ceiling. Refer to "Ceiling Cutout Size" in the Specifications section for the cutout size. 2. Connect mains cable. 3. Fold back spring clips and insert into cutout. 3 Colour temperature select Set the selector switch in the desired colour temperature 4 LED Downlight lamp life 35,000h Rated Average Lamp LED Life @ 25oC when installed with the default insulation insulation clearances specified by AS/NZS 3000-2007 20,000h Rated Average Lamp LED Life @ 25oC when installed with the thermal insulation abutting and covering the fixture in accordance with the IC-F rating specified in AS/NZS 60598.2.2 Warm Cool Natural Note: This from of installation complies with the Wiring Rules AS/NZS 3000:2007 requirement for recessed downlights, clause 4.5.2.3.1 (i). 5 Insulation Rating This series of downlights has achieved an IC-4 insulation rating in accordance with AS/NZS 60598.2.2. A type IC-4 luminaire can be installed with building insulation material that can safely be exposed continuously to temperatures up to 90°C. Such insulation can cover and abut the side of the luminaire. Refer to the diagram shown on the right for clarification. Combustible building element above fitting HCB >30mm Thermal Insulation SCB >5mm Joist Note: Not Suitable for use with loose-fill insulation. If installed in accordance with the IC-4 rating, insulation shall have a minimum temperature rating of 90oC. WARNING - RISK OF OVERHEATING OR FIRE IF THE CLEARANCE DISTANCES ARE COMPROMISED Required clearance from structural members and building elements SCB = 5mm HCB = 30mm SCB - Side Clearance to Building element: Minimum distance between the side of the recessed luminaire and any building element. HCB - Height Clearance to Building element: Minimum distance between the top of the recessed luminaire and any building element above it. 6 Dimming This series of downlights are dimmable with trailing edge dimmers only. We recommend the following dimmers only. DLI90TRIWE, DLI110TRIWE Cat No Legrand EM400A3P, AR400A3P Legrand EM400A2P Legrand EM400T, AR400T HPM 400T Legrand EM250T HPM 250T HPM 700T HPM1000T DOWNLIGHTS QTY PER DIMMER 12 max 12 max 12 max 12 max 8 max 8 max 21 max 30 max DIMMING RANGE 1% - 99% 5% - 86% 4% - 99% 4% - 99% 5% - 99% 5% - 99% 11% - 99% 13% - 100% Disclaimers 1. This product must be installed and used as per these instructions. 2. An IP rating of IP44 is generally considered suitable for external walls with supplementary protection such as overhanging eaves. 3. The IP rating of this product is only valid when installed on a flat and non-porous surface. Additional sealing may be required for irregular surfaces. 4. This product contains no serviceable parts and no attempt should be made to repair this product. If the product is faulty it should be discarded. 5. This product is not suitable for installation in hazardous and/or corrosive areas. 6. Electrical installations periodically receive transient over voltages. This product has been designed to minimise the effect of such voltages on connected equipment. It may not give full protection for extreme over-voltage transients such as those resulting from a close lighting strike. 7. This product utilises intellectual property in the form of registered designs, trademarks, and/or patents. Such intellectual property remains the property of HPM Legrand in all cases. 8. This product has been designed to operate in ambient temperatures: -10°C to 45°C. 9. The material in this product may vary in colour from batch to batch. Colour matching from one batch to another cannot be guaranteed. 10. HPM Legrand reserves the right to modify the specification of this product at any time. Warranty HPM Legrand warrants this product for a period of 3 years from the date of purchase. These goods come with guarantees that cannot be excluded under the Australian and New Zealand Consumer Laws. You are entitled to a replacement or a refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired if the goods fail to be of acceptable quality and the failure does not amount to a major failure. See the Warranty card enclosed with this product for further details. Customer Service For all Customer Service and Technical Support please call Monday to Friday during business hours. HPM Legrand Australia 1300 369 777 www.hpm.com.au ABN: 31 000 102 661 HPM Legrand New Zealand 0800 476 009 www.hpm.co.nz LE09070AAB HPML1198GPL Ghostscript 8.15 Adobe Acrobat 17.9.0